Home

Home > Products Catalog > PRIMUS WATER BASE > Special Effect Series > Block Out GT/GT-380

Block Out GT/GT-380

Block Out GT (Acrylic Base)
Block Out GT-380 (Polyurethane Base for Heat Transfer Sticker)

 
This product is a bleed resistance ink and entirely prevents dyed problem polyester fabrics, or blended, from migrating on printed area. It is grey tone and very opaque ink.
 
Specialty:
 
  • Good elastic and fully block out dyed problem disperse dyes.
  • Good soft hand.
  • PVC, phthalates, APEO, Azo, Formaldehyde and Lead Free formulations.Meets all key international environmental standards.
  • Non-tacky.
  • No harmful or distracting odors in the work place.
Guidance:
  • Use as an under base coat for printing on light to dark polyester fabrics.
  • It is recommended to print two times, dry in between, to get permanent anti migration performance.
  • In use of other Primusinks rubberized inks on top of Block-Out GT are excellent compatible with each other, which means there will be no layer separation occurred.
  • To meet superior wash, adding Additive Xlinker JF 2-4% by weight is necessary. After mixing Xlinker JF, it is recommended to consume mixed inks within 4-6 hours to avoid spoiled.
  • Avoid wet on wet printing application.
Precautions:
 
  • Keep the screen in the flooded position while print stops. Or, go for screen wash during a temporary stop.
  • Modification of Block-Out GT is not recommended as any adjustment may lessen the bleed resistance ability.
  • Containers must maintain air-tight seal while not in use.
  • During Production, heat application can be applied to speed up the process. Failure to cure ink at recommended time and temperature may result in poor fastness.
  • Screen must be prepared with water-resist emulsion to prevent stencil breakdown.
  • Any application not referred in this Product Information should be pre-tested or consulted with Primus Technical Service prior to print.

Printing Parameters:

100% Polyester, Cotton/Polyester blends Cure: 150℃ x 1.5 minutes
Durometer: 60-65
Edge: Rounded or Sharp
80-120t/in(32-47t/cm)
Additive Xlinker JF 2-4%
by weight.
Use within Six Months of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times.

Tap water 
Available upon request (MSDS)
 
All Rights Reserved by Primus Chemical Co.,Ltd.