CR Clear/White(Auto Crack)

Details:

This product series is a water base ink developed to produce automatic cracking, soft hand and good stretch on knitted fabrics. A ready product to use, It is available as a clear Base and as a White.

Specialty:

Very good elasticity.
Good all round fastness.
No Staining with foil.
PVC, phthalate, APEO, Azo and Lead Free formulations, Meets all key international environmental standards.
Soft finish prints.
No harmful or distracting odors in the work place.

Guidance:

Use 100-120 t/in mesh (39-47 t/cm)
To meet superior wash, adding Additive Xlinker JF 2-4% by weight is necessary.
Avoid wet on wet printing application.
Make a ground print by any Primusinks Premium Rubber Paste to make a smooth and even ground base, which helps a good performance while applying cracking on surface.
The thicker of CR Clear/White you print, the bigger cracking effect you get. Controlling surface dry in between is very important to avoid sudden crack.
Do not remove the printed fabric out of table before ink cracks completely. Otherwise, performance may not be satisfactory.

Precautions:

Keep the screen in the flooded position while print stops. Or, go for screen wash during a temporary stop.
Containers must maintain air-tight seal while not in use.
During Production, heat application can be applied to speed up the process. Failure to cure ink at recommended time and temperature may result in poor wash fastness.
Screen must be prepared with water-resist emulsion to prevent stencil breakdown.
Any application not referred in this Product Information should be Pre-tested or consulted with Primus Technical Service Prior to Print.

Printing Parameters:

100% Cotton/Poly Cotton/Blended

Cure: 150℃ x 1.5 minutes

Durometer: 60-70
Edge: Rounded or Sharp

100-120t/in(39-47t/cm)

Additive Xlinker JF
2-4% by weight.
Additive Retarder 3% Max.
by weight.

5-40℃
Use within one year of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times

Tap water

Available upon request (MSDS)